Repair of Opel Corsa C, from 2000 to 2005 release.
1. Operation and maintenance of the car
2. Engine
2.1. Petrol Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I engines
2.2. Mechanical part of petrol Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I engines
2.3. Cooling system
2.4. Lubrication system
2.5. System of injection
2.6. Petrol engines – the general procedures of check
2.7. Mechanical part of the engine
2.8. Test and repair operations of components of a mechanical part of the engine
2.9. Cooling system
2.10. System of injection of fuel of petrol engines
2.10.1. Removal and installation of fuel nozzles
2.10.2. Replacement of a fuel-supply line of high pressure (The pump of high pressure – the pressure chamber)
2.10.3. Module of the fuel pump
2.10.4. Replacement of the module of a dosage
2.10.5. Replacement of the regulator of pressure of fuel
2.10.6. Replacement of damping fuel return case
2.10.7. Replacement of the fuel level sensor
2.10.8. Fuel tank
2.10.9. Replacement of a tube of a jellied mouth of the fuel tank (petrol engines)
2.10.10. System of catching of vapors of fuel
2.10.11. Replacement of a forward ventilating tube
2.10.12. Removal and installation of container with absorbent carbon
2.10.13. Removal and installation of the sensor of a mass consumption of air
2.10.14. System of release (Z 14 XEP, Z 14 XEL, Z 16 XEP)
2.10.15. System of release (Z18 XE)
2.11. Lubrication system
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 





0653563c

2-10-12-snyatie-i-ustanovka-emkosti-s-aktivirovannym-uglem.html

2.10.12. Removal and installation of container with absorbent carbon

Removal
Disconnect lines with use of the special KM-796-A tool.
Remove a forward right wheel
Remove protective facing, a wing,
Disconnect the socket of a plait of wires from a lamp of the index of turn on a wing and remove a lamp of the index of turn
Turn off a bolt of fastening (shooter) and remove the container with absorbent carbon.

Installation
Establish the container with absorbent carbon and fix on a body.
Establish a lamp of the index of turn on a wing and attach the socket of a plait of wires to a lamp of the index of turn.
Establish protective facing, a wing.
Establish a wheel, tighten fastening bolts the moment of 110 N · m.
Attach lines.

"on the page back
2.10.11. Replacement of a forward ventilating tube
on the following page"
2.10.13. Removal and installation of the sensor of a mass consumption of air