Repair of Opel Corsa C, from 2000 to 2005 release.
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical box передч
3.3. Automatic transmission
3.3.1. General information
3.3.2. Hydrotransformer
3.3.3. Main transfer
3.3.4. Adjustment of a cable of the selector of switching of automatic transmission
3.3.5. Designation of the automatic transmission (AF 13-II)
3.3.6. Check of a condition of gearbox oil (AF13-II)
3.3.7. Check of pressure of oil (AF13-II)
3.3.8. Check of the position switch of the lever of gear shifting (AF13-II)
3.3.9. Unblocking of a stopper of the lever of gear shifting at violation of its work
3.3.10. Adjustment of the position switch of the lever of gear shifting (AF13-II)
3.3.11. Adjustment of hummock system of the drive of gear shifting (AF13-II)
3.3.12. Replacement of hummock system of the drive of gear shifting (AF13-II)
3.3.13. Replacement of the switch of lock adaptation of the lever of gear shifting
3.3.14. Replacement of a plait of wires in knot of the lever of gear shifting (AF13-II)
3.3.15. Replacement of the control unit of the electronic switch of the check point
3.3.16. Replacement of the glow lamp of the indicator of gear shifting in the console of the lever of gear shifting (AF 13-II)
3.4. Driving mechanism
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 





0653563c

3-3-15-zamena-bloka-upravleniya-ehlektronnogo-pereklyuchatelya-kpp.html

3.3.15. Replacement of the control unit of the electronic switch of the check point

NOTE
When replacing the control unit before demontazhy make dumping of data the TECH2 device.

Disconnect clips of the rechargeable battery.
Release and disconnect the socket of a plait of wires 1 and 3.
Wring out outside the fixing ledges 2 and take out the check point control unit forward.

NOTE
Depending on version of the engine and the check point differently calibrated check point control units are used. When replacing the control unit of the check point use the corresponding new block. It is ordered in the service center.

Fix the check point control unit in the holder.
Insert and fix 2 sockets of plaits of wires.
Attach clips of the rechargeable battery.
Program volatile memory devices.

NOTE
When replacing the control unit, after installation of the control unit, execute the appropriate program by means of the device.

"on the page back
3.3.14. Replacement of a plait of wires in knot of the lever of gear shifting (AF13-II)
on the following page"
3.3.16. Replacement of the glow lamp of the indicator of gear shifting in the console of the lever of gear shifting (AF 13-II)